Wheatlies
|
  |
| Joined: 30 Jun 2010 |
| Total Posts: 230 |
|
|
| 21 May 2013 03:11 PM |
| I need to generate a 400 x 6 x 400 block of water terrain, as a sort of baseplate. I I can create one via the generation tool, however I need to to start at 0, 100, 0 , not 0, 0, 0, and since roblox for some ungodly reason decided to include an x and a z offset but not a y one, I can't figure out how. |
|
|
| Report Abuse |
|
|
|
| 21 May 2013 03:49 PM |
| Insert a blue semi-transparent part at 0, 100, 0? |
|
|
| Report Abuse |
|
|
Wheatlies
|
  |
| Joined: 30 Jun 2010 |
| Total Posts: 230 |
|
|
| 21 May 2013 09:04 PM |
| I mean actual ROBLOX water. Like the rterrain object |
|
|
| Report Abuse |
|
|
Fir3bl4ze
|
  |
| Joined: 13 Jul 2012 |
| Total Posts: 310 |
|
|
| 21 May 2013 09:18 PM |
| Im pretty sure since the new update.... those two things are the same... they just have different names |
|
|
| Report Abuse |
|
|
69scott69
|
  |
| Joined: 30 Jan 2011 |
| Total Posts: 6136 |
|
|
| 22 May 2013 12:17 AM |
| Create an outline with terrain around where you want the water, then 'fill' it with the terrain stamper water tool. |
|
|
| Report Abuse |
|
|
Wheatlies
|
  |
| Joined: 30 Jun 2010 |
| Total Posts: 230 |
|
|
| 22 May 2013 01:48 PM |
| I can't have any terrain below the water, need it to be floating |
|
|
| Report Abuse |
|
|
69scott69
|
  |
| Joined: 30 Jan 2011 |
| Total Posts: 6136 |
|
|
| 26 May 2013 12:37 PM |
| Then make the outline, and put a base of terrain under it however thick you want it (just like building a pool) then delete the parts under the water. |
|
|
| Report Abuse |
|
|
|
| 26 May 2013 12:46 PM |
Set the point you want with a part. Now open stamper and go to high scalability blocks. Select the water block. Click and hold the mouse down on the part and a single waterblock will place, while still holding mouse down drag a line of blocks, while still holding mouse down click C and drag the line wider , while still holding mouse down click C again and drag the third dimension. Viola you have a large block of water , It wouldn't take long to get the size you want.
To do this all in one move set parts for all 4 corners of the water and one part for the height. Then start in one corner drag a line to the next corner, click C drag the line as wide as the other side parts, click C again and drag up to your height. |
|
|
| Report Abuse |
|
|