|
| 09 Jan 2013 01:00 AM |
When I drive my vehicle I made for a while, the wheels start to go crazy (The speed goes higher and the wheels sort of looking like they are coming of) And the vehicle becomes undrivable. Why is that? |
|
|
| Report Abuse |
|
|
69scott69
|
  |
| Joined: 30 Jan 2011 |
| Total Posts: 6136 |
|
|
| 09 Jan 2013 01:29 AM |
| Change the torque (in the VehicleSeat) value. Chances are the torque is set too high. If you lower it to where the car just turns well it should stop doing that. If you make it too low then it won't turn well when it is sitting still. |
|
|
| Report Abuse |
|
|
|
| 09 Jan 2013 01:47 AM |
| Well I've already done that one earlier in the process of the model building, could the speed be the cause to? |
|
|
| Report Abuse |
|
|
69scott69
|
  |
| Joined: 30 Jan 2011 |
| Total Posts: 6136 |
|
|
| 09 Jan 2013 01:52 AM |
Which vehicle? I looked at your models to see how many you had (to try to find out your level of building). Sometimes on longer trucks you have to increase the torque so much it is an issue. What is your torque and speed set at? |
|
|
| Report Abuse |
|
|
|
| 09 Jan 2013 01:55 AM |
Its a mobile crane Speed: 40 Torque: 25
You can find this mobile crane at this place:
http://www.roblox.com/EG-base-Being-worked-on-place?id=64816156 |
|
|
| Report Abuse |
|
|
69scott69
|
  |
| Joined: 30 Jan 2011 |
| Total Posts: 6136 |
|
|
| 09 Jan 2013 02:11 AM |
That is messed up! The wheels completely spazzed out on me after driving to the runway and the crane started bouncing all over the place. Are the wheels possibly doubled up in the model? I had a regen issue with one of my models that caused the model to regen 2x so the first time it had 2 sets of wheels, then 4, then 8, and it behaved kind of the same. I have no other answers. |
|
|
| Report Abuse |
|
|
|
| 09 Jan 2013 02:19 AM |
Hmmmm, if you noticed I have added a circle brick to the wheels (For design). Could that be the cause? |
|
|
| Report Abuse |
|
|
69scott69
|
  |
| Joined: 30 Jan 2011 |
| Total Posts: 6136 |
|
|
| 09 Jan 2013 02:25 AM |
It shouldn't be. Are square corners of the parts with the circle mesh in them extending outside the diameter of the wheels? On another note what is the elasticity of the wheels set at? |
|
|
| Report Abuse |
|
|
|
| 09 Jan 2013 02:29 AM |
| The elasticity of the wheels is 0.5 and I dont think it is extending outside the diameter of the wheel. |
|
|
| Report Abuse |
|
|
|
| 09 Jan 2013 02:29 AM |
| The elasticity of the wheels is 0.5 and I dont think it is extended outside the wheel. |
|
|
| Report Abuse |
|
|